qosango.blogg.se - Hyperterminal for windows 7 icon

Continue to configure the system's parameters as needed.Īfter you have assigned an IP address to the system, you can communicate remotely by running Telnet over an Ethernet network.

Host1(config)#interface FastEthernet slotnumber/0

Use an IP address valid for the system.Įnter configuration commands, one per line.

Substitute the slot number where the SRP module is located for the slotnumber variable. When Hyper Terminal is opened it will ask you to select an icon and to name the session.

Set an IP address on the Ethernet interface:.

Go to start and type in cmd in search box and press enter. There are several options you can use to accomplish the same tasks: If you only need remote shell access, you can use WinRS (Windows Remote Shell). Go to C:WindowsSystem32 and copy hticons.dll and hypertrm.dll to your USB flash drive. The system is now in Privileged Exec mode. Hi, Terminal mode is not included in Windows 7.

Enter the enable command at the User Exec prompt.

Someone else had a similar post for the missing Hyperterminal, but had a typo in the hticons.dll file. When your console is ready to communicate with the system, power up the system (see Chapter 7, Powering Up E-Series Routers), and set an IP address for the system. I forgot about this Vista omission until I recently moved a computer from XP to Windows 7 and have same problem. Note: Direct access through the RS-232 serial port allows you to monitor the system as it boots.